top of page

Syringe Warming Instructions:

Syringe and oil contents must be heated to ~98 degrees fahrenheit bef0re dispensing oil. The oil in the tip of the syringe will clog if not heated to appropriate temperature. The easiest way to do this is to put the syringe in your pocket for ~20 minutes before dispensing. This can also be acheived by using a blow dryer on the warm setting, or by holding the syringe under hot running water.

CBD crystallization:

Much like honey, high purity CBD has the tendency to crystallize over time. This is completely normal and does not mean that the product has gone bad. This issue can be remedied by

placing your syringe in a hot water bath. Within 10-15 minutes the crystals will remelt and you will be able to use the syringe again without issues. 

Here's what you will need:

- small pot

- thermometer

- slotted spoon

 

Simply fill the pot about half way with water. Begin heating the water on your stove top to 200 degrees fahrenheit and make sure the cap and plunger are twisted all the way shut. Once the water is at 200 degrees place the syringe in the water & leave for 10-15 minutes while maintaining a ~200 degree temp. Remove syringe with a slotted spoon and check for crystals, if crystals are still present just place the syringe back in the water and keep checking until they are all melted. This can be done as often as needed!

Please call customer service at (509)955-1877 if you have any questions on how to gently heat your oil syringe. We are happy to help! 

bottom of page